Quick release skewers

Discussion in 'Vendetta Series (V1.x, V2.x, V20)' started by Vangelo, Aug 15, 2014.

  1. Vangelo

    Vangelo New Member

    Where can I get QR skewers to fit the Vendetta front wheel to allow use on a trainer?
     
  2. Charles.Plager

    Charles.Plager Recumbent Quant

    My trainer came with such a

    My trainer came with such a skewer and fits both my Sofrider and my folding bike (so I'd guess it would fit the Vendetta as well). Yours didn't?
     
  3. ratz

    ratz Wielder of the Rubber Mallet

    The front wheel is just using

    The front wheel is just using a MTN bike length 135MM Skewer

    Most trainers accept this type:

    Skewer
     
  4. Vangelo

    Vangelo New Member

    Not that simple. Vendetta QR

    Not that simple. Vendetta QR top, Tacx QR bottom [​IMG] Vendetta is not standard MTB size.....There is an extra BB support for the V.


    [​IMG]
     
  5. John Tolhurst

    John Tolhurst Zen MBB Master

    That model is not a standard

    That model is not a standard skewer size. A more slender set of dropouts was on the subsequent release.

    You can use a bit of 5/32 or 5mm threaded rod with nuts at either end, was one solution worked out.
     
  6. Vangelo

    Vangelo New Member

    Thanks John...that explains

    Thanks John...that explains it!
     

Share This Page